This section describes some of the typical maintenance and fault finding features found on modern programming software. The programming software is not just used for the obvious task of writing the program, it is also a valuable aid for fault finding. Modern programming software also comes with many useful diagnostic aids as described in the following section. Previously this would have been done with several rungs of program. 8.6 Electromagnetic compatibility (EMC) and CE markingĮntry and drag set-up for scaling of an analog input card and alarm setting on one channel of an analog input card.8.5.2 Statistical representation of reliability.7 Industrial control with conventional computers.6.6.3 Pixel graphics the CEGELEC Imagem.6.2 Simple digital control and indicators.5.6 Safety and practical considerations.4.4.4 Channel selection and conversion to engineering units.4 Analog signals, closed loop control and intelligent modules.3.5 Housekeeping and good software practice.2.3 Identification of input/output and bit addresses.1.3.5 Requirements for industrial control.1.3.2 Machine code and assembly language programming.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |